How to install ?

1, release the PVC bag package in the line 1-2-3-4....all parts(1,2,3,4....package bags close to each other), put them on the ground/place where the protection ground sheet lying flatly there that ready for the parts/tent.

2, Open each rolls accordingly,find out the location of the Valves or blower air pipes on as well as the Steel D shape rings, to tie with long nylon ropes; Get the air pumps/blowers ready in position(the air pump/blower with valves/air blower tubes to be joined/connected, press the botton”turn on”, the tent is inflating automatically

3, during the process of inflating, 1people has to check whether the air pumps/blowers is working rightly or not please(cause the tent is moving....),meanwile,to see where there may have some difficulty or blocks of poped up, assist or remove it by pulling till it goes flatly, when the tent is going up(about 80% full with air), collect all people,one by one part, getting them fixed uprightly with the long nylon ropes to make it be in a right way, then put all separated parts close tight to each other.

4, meanwhile, get the sand bags or spike stakes,ropes ready for anchoring, as well as the connecting Velcro PVC flaps between the gaps of two parts(the long arm lift truck with chamber needed for giant tent if necessory). by using the connecting Velcro PVC flap to cover the gap between two parts from one end to another, with ladder or the lift truck.

5, For sealed/airtight tent, after 15-30days usually,have to check and depends whether need to add a little bit more air or not, then can last for another period of time outside upright working there, like this and so on.